Purpose Of This Manual; Safety Information - Battipav DYNAMIC 1200 Manual De Instrucciones

Battipav srl

PURPOSE OF THIS MANUAL

This manual is an integral part of the machine. It was produced by BATTIPAV S.R.L. to provide those authorised to work with the
machine with the information required for its foreseeable lifespan. Before starting to use this machine read the safety chapter
carefully. Each machine is subjected to a series of tests and carefully checked before leaving our factory. BATTIPAV S.R.L. is
constantly striving to develop their machines and therefore reserves the right to make any change without prior notice. Therefore,
no claims may be made on the basis of the data and illustrations contained in this manual.

SAFETY INFORMATION

• The manufacturer accepts no responsibility where the DYNAMIC cutter is used with any tools other than those specified in the
"RECOMMENDED USE" paragraph.
DO NOT USE WOODEN DISCS. DO NOT USE DRY-CUTTING DISCS.
• DYNAMIC is made to operate exclusively under the conditions indicated under "TYPE OF OPERATION ALLOWED", in the
"RECOMMENDED USE" paragraph.
• During cutting operations, allow the machine to rest as indicated.
• DYNAMIC is not made for use with a continuous load.
DO NOT USE DIAMOND TIPPED DISCS OF LOW QUALITY OR THAT ARE NOT SUITABLE FOR THE SPECIFIC
USE FOR WHICH THE MANUFACTURER SUPPLIED THEM. THE USE OF POOR QUALITY DISCS CAN HARM
THE OPERATOR AND DAMAGE THE MACHINE, AS WELL AS SIGNIFICANTLY SLOWING THE WORK. THE
MACHINE IS NOT INTENDED FOR USE IN AN EXPLOSIVE ENVIRONMENT. ALWAYS USE INDIVIDUAL
PROTECTION DEVICES TO REDUCE THE RISKS CAUSED BY WORK. NEVER START THE MACHINE WHEN
THE CUTTING TOOL IS MOVING; WAIT FOR IT TO STOP.
Warning! When using electric tools, following safety precautions should always be followed to reduce the risk of fire, electric shock
and personal injuries. Read and follow all these instructions before attempting to operate this product and save them with care!
Keep your work area perfectly clean
• Cluttered areas invite injuries.
Consider work area environment
• Don't expose tools to rain.
• Don't use tools in damp or wet locations. Keep work area well lit.
• Don't use tools in presence of flammable liquids or gases.
Guard against electric shocks
• Prevent body contact with grounded surfaces.
Keep children away!
• Do not let third parties contact tool or extension cord. All visitors should be kept away from work area.
Store your tools in a save place
• When not in use, tools should be stored in dry and save places, out of the reach of children.
Don't force tool
• It will function better and in a safer way at the rate for which it was intended.
Use the right tool
• Don't use low duty tools or accessories to do the job of a heavy-duty tools. Don't use tools for purposes not intended.
Dress properly
• Rubber gloves and non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long
hair. Use safety glasses.
• Use a mask if working operations are dusty.
Don't abuse cord
• Never carry tool by cord or yank it to disconnect it from socket.
• Keep cord from heat, oil and sharp edges.
Avoid unsteady positions
• Be sure to work in a safe and balanced position.
Maintain tools with care
• Keep tools sharp and clean for better and safer performance.
• Follow all maintenance advice and instructions to replace accessories subject to wear. Inspect tool cords periodically and, if
damaged, have them repaired by an authorised expert. Check extension cords periodically and replace them if damaged. Keep
handles dry, clean and free from oil and grease.
Disconnect tools
• When not in use, before servicing, and when changing accessories subject to wear.
"TRANSLATION OF THE ORIGINAL INSTRUCTIONS"
SAVE THESE INSTRUCTIONS WITH CARE.
GB
23