Battipav DYNAMIC 1200 Manual De Instrucciones página 25

Battipav srl
MANUFACTURER AND MACHINE
The nameplate shown is fitted directly on the machine. It indicates all the references and information necessary for safe operation.
42
A Machine model
B Item
C Serial number
D Power supply voltage
E Power supply frequency
F Current absorption
G Installed power rating
H Tool rotation speed
I Class of protection
L Starter capacitor
INSTALLATION
TRANSPORT
The DYNAMIC machine can be easily moved by using the transport handles.
Before carrying the machine make sure that:
• the motor carriage is locked by means of the locking knob located on the slide rail;
2
• the legs are in transport position;
• the motor head is locked by means of the locking lever;
1
• the sliding carriage is in the locked position;
2
To move the machine, use a four-arm tie rod with the capacity to lift 200 kg or at least 20% more than the machine weight,
by making use of the hooks in the transport handles.
HANDLING
By using the "transport wheels" accessory, the machine can be moved with the aid of a second person.
IN ORDER NOT TO COMPROMISE THE MACHINE STABILITY, KEEP STRICTLY TO THE FOLLOWING PROCEDURES.
WITH THE AID OF A SECOND PERSON, HOLD THE MACHINE DURING THE WHEEL KIT INSTALLATION OPERATIONS.
When the machine is in working position (See paragraph: Positioning):
a) loosen the left leg locking pin (motor side);
3
b) lift the leg and put it in the wheel support;
c) lock the leg with the relative locking pin;
3
d) tighten the wheel support setscrew;
e) repeat the operation for the right wheel.
IN ORDER TO FACILITATE THE PRIME/SUPREME MACHINE MOVEMENT IN THE YARD, WE RECOMMEND LOWERING IT UNTIL
THE LOWERED POSITION WITH THE AID OF A SECOND PERSON AS DESCRIBED BELOW:
a) loosen the leg locking pins on the front side, one at a time, holding the machine from the transport handles;
4
b) lower the machine front side, making the legs slide inside the supports until the leg middle hole matches the hole of the
supports (see picture 5);
c) lock the legs by means of the relevant leg locking pins;
d) repeat the operations indicated in points (a), (b), (c) for the rear side.
6
LOCK THE CARRIAGE AND THE MOTOR HEAD BEFORE MOVING THE MACHINE.
5
MOVE THE MACHINE
POSITIONING
Place the machine on a stabile surface. To place the machine in working position, proceed as follows:
MAKE SURE THAT:
1) THE BALANCING MOTOR HEAD IS LOCKED BY MEANS OF THE LOCKING LEVER
2) The carriage is blocked in motor head with the locking knob and the pad safety in the transport position
7
a) put the leg locking pins in release position ;
8
b) by means of the transport handles, lift one side of the machine until the working position.
FOR CORRECT MACHINE POSITIONING, MAKE SURE THAT THE LEG UPPER HOLE MATCHES THE LEG COUPLING
HOLE, BEFORE FINALLY LOCKING IT.
8
c) lock the legs one at a time;
M IP Level
N Year of manufacture
O Max tool diameter
P Internal tool diameter
Q Accessories
R Accessories
S Manufacturer's name
T Manufacturer's name and address
U Certification Marks
GB
25