Dash Disassembly - Metra 95-7617GHG Instrucciones De Instalación

1. Unclip the right side of the driver's
knee bolster panel next to the
center console and let hang. Note:
There is no need to completely
remove the panel. (Figure A)
2. Unclip and remove the (2) silver
side trim panels from each side of
the factory radio. (Figure B)
3. Unclip and remove trim panel
below the a/c control panel.
(Figure A)
99-7617GHG

Dash Disassembly

(Figure B)
(Figure C)
4. Remove (4) Phillips screws
securing the factory radio, a/c
control and a/c vents. (Figure C)
5. Remove the a/c controls.
(Figure D)
6. Remove the a/c vent panel.
(Figure E)
7. Remove the factory radio.
(Figure F)
8. If equipped there may be an a/c
amp present attached under the
radio remove (2) Phillips screws
securing the a/c amp.
Continue to kit assembly
2
(Figure D)
(Figure E)
(Figure F)