Tabla De Contenido; Package Contents; Installation - VWR 444-7084 Manual De Instrucciones

T
ABLE OF
Package Contents . . . . . . . . . . . .
Installation . . . . . . . . . . . .
Maintenance & Servicing . . . . . . . . . . . .
Environmental Conditions . . . . . . . . . . . .
Intended Use . . . . . . . . . . . .
Equipment Disposal . . . . . . . . . . . .
Safety Instructions . . . . . . . . . . . .
Standards & Regulations . . . . . . . . . . . .
Control Panel . . . . . . . . . . . .
Specifications . . . . . . . . . . . .
Operating Instructions . . . . . . . . . . . .
Troubleshooting . . . . . . . . . . . .
Replacement Parts . . . . . . . . . . . .
Accessories . . . . . . . . . . . .
1
C
ONTENTS
1
1
2
2
2
2
3
3
4
5
5-8
8
9-10
11-12
P C
ACKAGE ONTENTS
Incubating Orbital Shaker
Non-skid rubber mat
234cm detachable power cord
Instruction manual
I
NSTALLATION
Upon receiving the VWR Incubating Orbital Shaker, check to ensure
that no damage has occurred during shipment. It is important that
any damage that occurred in transport is detected at the time of
unpacking. If you do find such damage the carrier must be notified
immediately.
After unpacking, it requires two (2) people to lift the Incubating
Orbital Shaker, from the bottom, to place on a level bench or table,
away from explosive vapors. Ensure that the surface on which the
unit is placed will withstand typical heat produced by the unit.
Always place the unit on a sturdy work surface.
The Incubating Orbital Shaker is supplied with a power cord that is
inserted into the IEC connector on the back of the unit first, then it
can be plugged into a properly grounded outlet. The 230V unit plugs
into a 230 volt, 50/60 Hz source.