Taking A Reading - Object - MABIS Healthcare RediScan 18-535-000 Instrucciones

Taking a Reading - Person
temperature reading, Fig. 7. The display will
6. The thermometer will beep once and show the
illuminate with Nite-Glo ® technology for 3 seconds.
NOTE: A happy face symbol
if the temperature is below 100.4°F (38°C). If the
temperature reading is above 100.4°F (38°F), a sad
face symbol will appear.
If the temperature is outside of the thermometer's sensory range, 'Lo' or 'Hi'
will appear on the display. If however, the temperature is outside of the
thermometers permissible measurement range, 'Err' will appear on the
display.
7. The thermometer will automatically beep and shut-off after
approximately one minute of non-use.
NOTE: To ensure accuracy:
• Please wait at least 1 minute between successive readings.
• Clean the probe lens before and after each use.
will appear on the display
10
Taking the Temperature of an Object:
NOTE: Be sure the thermometer is set to measure the
temperature of an object.
1. If the thermometer is off, press the 'Power' button
to turn the thermometer on.
appear like Fig. 8.
Fig. 7 2. Press and hold the 'SCAN' button. The screen should
3. Aim the front of the
the object, Fig. 9. Hold
thermometer at the
the thermometer approximately
2" to 3" away from the object
and release the 'SCAN' button.
4. The thermometer will beep
temperature reading, Fig. 10.
once and show the
The display will illuminate with
Nite-Glo ®
3 seconds.
5. The thermometer will automatically beep and shut-off
after approximately one minute of non-use.

Taking a Reading - Object

technology for
11
Fig. 8
2"-3"
Fig. 9
Fig. 10