Ecco 3800 Serie Instrucciones De Instalación Y Funcionamiento

3800 series 3812 LED heads are compact directional
LED warning lights suitable for mounting anywhere on
a vehicle. Colourless until illuminated, these discrete
LED heads feature encapsulated electronics offering a
high degree of environmental and vibration protection.
Additional benefits of these LED lights include low
current draw and a long and maintenance free service
life. These LED heads operate at 12-48V, and have
multiple user-selectable flash patterns.
Failure to install or use this product according to manufacturer's recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Do not install and/or operate this safety product unless you have read and understood the
safety information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are
essential to ensure the safety of you and those you are seeking to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output
performance of the system is maximised and the controls are placed within convenient reach of the operator so that s/he
can operate the system without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the
vehicle operator should ensure that the projection of the warning signal is not blocked by vehicle components (i.e.,
open trunks or compartment doors), people, vehicles, or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an
intersection, driving against traffic, responding at a high rate of speed, or walking on or around traffic lanes.
7. This equipment is intended for use by authorised personnel only. The user is responsible for understanding and obeying
all laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and
regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.
Contents: 3812:
1 x 3812 Surface Mount LED Head
1 x Installation and Operating Instructions
2 x Front mounting screws (#8 x 1 1/4)
1 x Mounting gasket
Page 1 of 3
P/N 920-3802-00 (Rev C) 2016-08-12
© 2016 at ECCO
Installation and Operation Instructions
3800 Series Surface Mount LED Heads
Specifications:
Size: 3812: 5,8" (14.73cm) length, 1,9" (4.82cm) width,
1,2" (3.04cm) height
Weight 3812: 0.14 kg
Input Voltage: 12-48 VDC
Red:
Current Draw:
Amber:
Blue:
White:
0.46 Amps at 12.8 VDC
0.67 Amps at 12.8 VDC
0.65 Amps at 12.8 VDC
0.74 Amps at 12.8 VDC
Head Quarters ECCO Safety Group
833 West Diamond St
Boise Idaho,83705
Customer Service
USA 800-635-5900
UK+44 (0)113 2375340
AUS +61 (0)3 63322444
www.eccosafetygroup.com