Mount Led Follow Spot - Leviton LEO LEDFS-STD Guia Del Usuario

MOUNT LED FOLLOW SPOT

• Ensure the tripod is standing securely on a horizontal and solid floor.
• Ensure all locks and nuts are securely fastened.
• Ensure the tripod is opened wide enough to support the LED Follow Spot (min. 28").
• Prepare the LED Follow Spot. Adjust the yoke of the LED Follow Spot to vertical position.
• Unscrew the hex lock nut.
• Insert the mounting hole of the LED Follow Spot yoke to the M12 stud of the Follow Spot spigot.
• Fasten the hex lock nut back to the spigot M12 stud.
• Check the LED Follow Spot to ensure it's securely installed on the tripod.
NOTE: The tripod legs can be fully opened up to 34 inches wide.
Hex Lock Nut
M12mm
Stud
Lock
Lock
Lock
Lock
4