Macros; Macro Setup - Philips SRU6080 Manual Del Usuario

Macros

The MACRO button, in conjunction with digits 1 through 8,
lets you to program and store up to 8 sequences of IR
Commands (button-presses) of your choice. One press of
the respective Macro digit button results in that sequence
of IR commands being sent. Any sequence of commands
that you regularly perform can be reduced to two button
presses (MACRO button followed by digit 1 through 8
button). For example pressing MACRO followed by a
single button can turn on your TV, turn on your cable box,
change to your favorite channel, turn on your VCR, and tell
it to record, etc. A total of 20 button presses can be stored
under each of the 8 Macro digits.
To Setup a Macro
1. Press and hold the SETUP button until CODE SETUP is
displayed (takes about 3 seconds), then release the SETUP
button.
2. Press the down navigation button until MACRO SETUP
is displayed. Press and release OK.
3. MACRO SET is displayed. Press and release OK.
4. MACRO KEY? is displayed. Press and release digit button
1 thru 8 where you want to store the Macro.
5. MACRO X MODE? (where "X" is 1, 2, ..., 7, 8) is displayed.
Press and release the desired Mode button (TV, VCR, DVD,
etc.). The first button in a Macro sequence must always
be a Mode button.
6. MACRO X KEY? is displayed along with the button count
(initially 02). Press and release the buttons you want to
be included in the Macro, in the order you want them to
be sent (up to 20).
7. To store the Macro at any point, press and release the
Macro button. Note the Macro will be stored automatically
on the 20 button press.
th
8. SUCCESS is displayed and the remote exits Setup Mode
and returns to normal operation.
MACRO
button
24
Macros, cont.
In normal operation, to activate the Macro press and
release the MACRO button followed (within 20 seconds)
by the digit button 1 thru 8. MACRO X is displayed while
the Macro sequence is being carried out then remote
returns to normal operation. If no Macro is stored under the
chosen digit key then MACRO X VOID is briefly displayed
and the remote returns to normal operation.
Macro Notes
1. You might want to add "delays" in a Macro sequence
(e.g. to allow for your TV warm-up time). Delays can be
added by using the PAUSE button followed by the
number of seconds delay required. For example, to enter
a delay of 3 seconds, press and release PAUSE followed
by 3 (in step 6 of "To Setup a Macro" on the previous
page). Maximum delay is 9 seconds. It is not possible
to have a "0" digit entered after Pause i.e. there is no
zero delay.
2. There is an automatic delay of half a second between
each IR transmission in a Macro sequence.
3. * The first button in a Macro sequence MUST be a
Mode button (TV, VCR, etc.).
4. Setup and Macro buttons cannot be included in a
Macro.
5. Press SETUP to quit Macro Setup.
To Delete a Macro
1. Press and hold the SETUP button until CODE SETUP is
displayed (takes about 3 seconds), then release the SETUP
button.
2. Press the down navigation button until MACRO SETUP
is displayed. Press and release OK.
3. Press the down navigation button until MACRO CLEAR
is displayed. Press and release OK.
4. MACRO KEY? is displayed. Press and release digit key
1, 2, ...7 or 8 for the Macro you want to delete.
5. CONFIRM CLEAR is displayed. Press and release OK.
6. PLEASE WAIT is briefly displayed and the remote exits
Setup Mode and returns to normal operation.
25