D+H LDH 800/070-L Manual Original página 4

Intended use
- Drive for electric opening and closing for Hahn
louvre windows
- The louvre must be prepared by the louvre
manufacturer for the application of the drive
- Operating voltage 24 V DC
- Usable for smoke extraction as well as daily
ventilation
- Only for inside mounting
Safety notes
Operating voltage 24 V DC!
Do not connect directly to the mains supply!
- Connection has to be carried out only by an
authorized electrical specialist
- Danger of violent pressure in handaccessible area
- Keep away People from the operating area of the
drive
- Keep away children from the control
- Use only in dry rooms
- Only for inside mounting.
Use rain detector with danger of rain
- Just use unchanged original D+H parts
Observe enclosed red safety slip!
Mounting notes
- Cable entry must be carried out from the top
- The louvre must be prepared by the louvre
manufacturer for the application of the drive
Declaration of Conformity
We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following directives:
2004/108/EC, 2006/95/EC
Technical file at:
D+H Mechatronic AG, D-22949 Ammersbek
Thomas Kern
Member of the Board
05.11.2014
4/12
LDH 800/070 -L/-R
Maik Schmees
Authorized signatory, Technical Director
Performance Features
®
- Microprocessor controlled synchro electronics
for a precise synchronous run of up to 2 drives
(Tandem programming required by SCS software)
- Individually programmable (via software SCS)
- Protection system for the main closing edge
Extent of supply
Drive unit with 2,5 m silicone cable.
Without tappet driver and screws.
Starting
Do not run the drive without the tappet driver,
otherwise the drive could be damaged.
A reference run must be carried out for the first
starting and after exchange of one of the drives. In
this process the drive will determine its zero point
(Closed-position). This single event is called null
balance.
- Connect drive
- Trigger drive in CLOSED-direction
(independent on the position of louvres)
After an overload cutoff has been effected in
running direction „CLOSED", the drive will have a
new zero point. During the reference run, no
obstacle must impair the running of the louvres.
The hand guard in arms's reach is
deactivated during the reference
run (danger of squeezing)!
Disposal
Electrical devices, accessories and packaging
should be sorted for environmental-friendly recycling.
Do not dispose electrical devices into household
waste!
Only for EC countries:
According the European Guideline 2002/96/EC for
waste electrical and electronic equipment and its
implementation into national right,
electrcal devices that are no longer
usable must be collected separately
and disposed of in an environmentally
correct manner.
English 99.823.44 2.0/11/14