Indel B DT PLUS Serie Instrucciones Para El Uso página 13

• take the pin D out from its seat and fit it into the opposite one;
• fit the top pin into the hole of the front panel E opposite its previous position;
• put the plate A back using the relevant screws (see figure 05).
A PPLY I N G TH E D R A F T
(see figure 06)
The draft is a device - consisting of two parts, A and B - which connects the door of the Minibar to
the door of the piece of furniture it is fitted into, both when opening and when closing.
To install the draft, proceed as follows:
- screw the part A onto the door of the Minibar;
- open the door of the Minibar by 90°;
- screw the part B, perfectly horizontal, to the inside of the leaf of the piece of furniture, and fit it
into the part A so it can work as a sliding guide.
M AINTE NAN CE
• Regularly clean the inside and outside of the refrigerator using only warm water and a neutral
detergent.
• Subsequent to washing, rinse with clean water and dry thoroughly using a soft cloth.
• Do not use the following: special glass and mirror cleaning products, liquid, powder, or spray
detergents, alcohol, ammonia or abrasive products.
• If you are not using the minibar, we suggest cleaning it well inside and leaving the door ajar to
ventilate the interior.
In the event of failure or a technical fault, make sure that:
a) the plug is correctly plugged into the mains socket;
b) the mains voltage corresponds to the voltage shown on the TECHNICAL DATA table;
c) the switch is not at the position "0";
d) the fridge is not near sources of heat or exposed to sunlight.
e) the refrigerator is installed in such a way, to respect the ventilation openings.
O N LY FO R SA LE S W ITH I N TH E E U R O PE A N CO M M U N IT Y (E U)
This appliance is marked according to the European Directive 2012/19 / EU (WEEE). The symbol on
the product indicates that this product should not be treated as household waste.
Ensure that this product is not entered as part of the flows of municipal waste but treated as
professional WEEE.
13