Naxa NPB-426 Manual De Instrucciones página 23

shout-outparts that could result in a fire or electric shock. Never spill
liquid of any kindon the product.
16. Servicing: Do not attempt to service this product yourself as open-
ing orremoving covers may expose you to dangerous voltage or other
hazards.Refer all servicing to qualified service personnel.
17. Damage Requiring Service: Unplug this product from the wall outlet
and refer servicing to qualified service personnel under the follow-
ing conditions:a) when the power-supply or plug is damaged; b) if
liquid has been spilledor if objects have fallen into the product; c) if
the product has been exposedto rain or water; d) if the product does
not operate normally by following theoperating instructions. Adjust
only those controls that are covered by theoperating instructions as
improper adjustment of other controls may resultin damage and will
often require extensive work by a qualified technician to restore the
product to its normal operation; e) if the product has been dropped or
damaged in any way; f) when the product exhibits a distinct change in
performance—this indicates a need for service.
18. Replacement Parts: When replacement parts are required, be sure
thatyour service technician has used replacement parts specified
by the manufactureror have the same characteristics as the original
part. Unauthorizedsubstitutions may result in fire, electric shock, or
other hazards.
19. Safety Check: Upon completion of any service or repairs to this
product,ask the service technician to perform safety checks to ensure
that the productis in proper operating condition.
20. Wall or Ceiling Mounting: The product should be mounted to a wall or
ceiling only as recommended by the manufacturer.
21. Heat: The product should be situated away from heat sources such as
radiators,heat registers, stoves, or other products (including ampli-
fiers) thatproduce heat.
www.naxa.com
FCC NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful in-
terference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to ra-
dio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be de-
termined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Page 23