Custom-Cut Baffle Adjustment - Scag Power Equipment SZC Serie Manual Del Operador

Section 6
Cutter Deck Height
The cutter deck height adjustment is made to ensure that
the cutter deck is cutting at the height indicated on the
cutting height index gauge. To check for proper deck
height, be sure that the mower is on a flat, level surface
and the tires are properly inflated.
1. Place the cutter deck in the transport position.
Loosen the jam nuts on both ends of the deck height
control rod. (See Figure 6-5)
LOOSEN
HERE
CONTROL ROD
Figure 6-5. Cutter Deck Height Adjustment
2. Turn the control rod (See Figure 6-6) until there is a
1/4" space between the rear deck stop and the top of
the cutter deck. (See Figure 6-6). Tighten the jam
nuts on the control rod.
Figure 6-6. Cutter Deck Stop
1/4"
DECK
STOP
SZC 2005 CDS
3. Check the cutter deck cutting height by placing the
lanyard pin in the 3" position on the cutting height
index. Release the deck from the transport positon
and allow the deck to move to the 3" cutting height
position.
4. Check the measurement from the floor to the cutter
blade tip. If the measurement is not at 3", an
adjustment can be made using the deck height
control rod. (See Figure 6-5)
If an adjustment had to be made, be sure that the
cutter deck can easily be locked into the
transport position.

Custom-Cut Baffle Adjustment

The Custom-Cut Baffle is designed to deliver optimum
airflow and superior cutting performance in any type of
grass. The Custom-Cut Baffle can be raised or lowered
to precisely tailor the deck's performance for the type of
grass being cut. The baffle can be set in three (3)
different positions for optimum performance.
A. 3" Position - baffle is installed using the top set of
holes on the front baffle welded inside the cutter
deck. (See Figure 6.8). The Advantage cutter deck
will deliver the best quality-of-cut in very tall, wiry,
tough to cut grass.
B. 3-1/2" Position (factory setting) - baffle is installed
using the middle set of holes on the front baffle
welded inside the cutter deck. (See Figure 6.9). For
general purpose cutting, place the Custom-Cut Baffle
in the 3-1/2" position. This gives the best mix of
cutting performance in all types of grass.
C. 4" Position - baffle is installed using the bottom set of
holes on the front baffle welded inside the cutter
deck. (See Figure 6.10). Placing the baffle in the 4"
setting will enhance fall cutting (leaf pickup) and
reduce cutter deck "blowout".
27
-NOTE-