Lubrication Fitting Points - Scag Power Equipment SZC Serie Manual Del Operador

MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)
HOURS
Break-In 8 40 100 200 500
(First 10)
7.2 LUBRICATION - GREASE FITTING LUBRICATION CHART
(SEE FIGURE 7-1)
LOCATION
1 Caster Wheel Pivot *
2 Caster Wheel Bearings
3 Brake Actuator
4 Cutter Deck Bellcranks
5 Cutter Deck Pusharms
6 Control Pivot
7 Cutter Deck Spindle
8 Brake Handle
* PROCEDURE: Remove grease cap, part number 481559. Remove plug, part number 482028-01, and install
grease zerk. Apply grease to the fitting until new grease appears at the top of the caster extension. Remove the
grease zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number 47007, is recommended for
use in the installation of the grease cap.
+ Compatible Greases:
Procedure
X Apply grease to fittings
X Check hardware for tightness
X Change engine oil filter
X Check hydraulic oil level
X Replace engine fuel filter
X Drain hydraulic system and
replace hydraulic oil
X Replace hydraulic oil filter
X Adjust electric PTO clutch
LUBRICATION
INTERVAL
500 Hours/Yearly
100 Hours/Bi-Weekly
200 Hours/Monthly
100 Hours/Bi-Weekly
100 Hours/Bi-Weekly
100 Hours/Bi-Weekly
40 Hours/Weekly
200 Hours/Monthly
Mobilix #2 found at Mobil Service Stations
Ronex MP found at Exxon Service Stations
Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
Shell Alvania #2 found at Shell Service Stations
Lidok EP #2 found at industrial shops
LUBRICANT
Chassis Grease
Chassis Grease
Chassis Grease
Chassis Grease
Chassis Grease
Chassis Grease
+Lithium MP White Grease 2125
Chassis Grease
30
Section 7
Comments
See paragraph 7.2
See paragraph 7.4
See paragraph 7.3
See paragraph 7.5
See paragraph 7.3
Use SAE 20W50
Motor Oil
See paragraph 7.3
See Scag Dealer
NO. OF
PLACES
2
2
2
4
2
2
3
1