Guarantee And Service; Troubleshooting - Philips HR2020 Manual Del Usario

storage
Note: Make sure the blender is clean and dry when you store it.
1 To store the mains cord, wind it round the reel in the base of the motor unit (Fig. 6).
 Screw the blade unit anticlockwise onto the bottom of the blender jar.
 Turn the blender jar upside down.
 Put the blender jar on the motor unit.
Note: Make sure the handle of the blender jar is at the back of the motor unit.
5 Place the lid on top of the blender jar (Fig. 7).
Disposal
- Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 8).

Guarantee and service

If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local
Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal
Care BV.

Troubleshooting

Problem
The appliance does not
work.
The motor produces
an unpleasant smell
during processing.
The appliance
stopsrunning because
theblade unit is
blocked.
The blender jar leaks.
Solution
Check if you have plugged in the appliance. Also check if the blender jar
is properly attached.
It is common for a new appliance to give off an unpleasant smell or
emitsome smoke the first few times it is used. This phenomenon stops
after you have used the appliance a few times. The appliance may also
give off anunpleasant smell or emit some smoke if it has been used too
long. In this case switch off the appliance and let it cool down to room
temperature.
Switch off the appliance and use a spatula to dislodge the ingredients
that block the blade unit. We also advise you to process a smaller
quantityand/or to cut ingredients into smaller pieces before you put
them in theblender jar.
Switch off the appliance and pour out the ingredients. Then remove the
bladeunit. Check if the sealing ring is assembled properly on the blade
unit.
EnglisH