Celestron 44420 Guía De Inicio página 4

You can select file association (or defer to a later
time) and then click "Next".
Now that the Ulead software is installed, you will need to install the driver for the microscope imager.
Put the CD-ROM back into your CD/DVD drive.
As with the software installation, you
will choose which action to take to open
the CD-ROM and then click on "OK".
Now, double click on "setup" and it will take you
to the InstallShield Wizard.
The Ulead software installation has been installed.
proceeding to install the driver for the imager, you need to restart
your computer. Before restarting, remove the CD-ROM from
the drive and close all open programs. Then, click "Finish".
This screen also appeared during the software
installation, but this time you will double click on
"driver" which is highlighted here.
The installation will begin after you click "Next".
4
Before