Setting The Lcd Screen Settings - Milwaukee M18 2970-20 Manual Del Operador

2 M18™ WIRELESS MONITOR
M18™ 500GB CONTROL HUB – The CONTROL HUB is powered by its M18™
BATTERY which is hot-swappable. If the battery is removed from a running CONTROL
HUB, the below message will appear warning that the CONTROL HUB is operating on
the internal backup battery for a period of nine minutes. During these nine minutes a
charged M18™ BATTERY must be installed, or a USB-C cable must be attached between
the WIRELESS MONITOR and CONTROL HUB. The USB-C cable will now power the
WIRELESS MONITOR temporally.
Typical battery life: M18™ WIRELESS MONITOR: Nine hours on a fully charged battery
2019/10/23 01:47:57 AM
2019_10_23_SCREEN

2.2.12 Setting the LCD SCREEN SETTINGS

This setting adjusts the M18™ WIRELESS MONITOR LCD screen settings.
1. Turn the navigation dial to SETTINGS
2. Turn the navigation dial to SCREEN SETTINGS, press to enter the sub-menu.
3. Use the navigation dial to navigate through the menu choices, press the navigation
dial to select one.
4. Turn the navigation dial left and right to adjust the setting, press the navigation dial to
accept it.
5. Scroll to the bottom of the sub-menu and press the navigation dial on OK to accept the
changes.
M18™ 500GB CONTROL HUB: Nine hours on a fully charged battery
CAMERA LIGHT CAMERA LIGHT
Replace Control Hub battery or
Connect Cable to Wireless Monitor
Time remaining : 08:51
Hue
Brightness
Contrast
Saturation
Backlight
Cancel
immediately
, press the navigation dial.
50
50
50
50
8
OK
24
9.3FT