Seat Adjustment Lever; Bypass Linkages; Fuel Shut Off Valve; Tracking - Husqvarna Z 254 Manual Del Operador

CONTROLS

Seat Adjustment Lever

The seat can be adjusted lengthways. When
making adjustments, the lever below the right side
of the seat is pulled up, after which the seat can
be moved backward or forward.

Bypass Linkages

Transaxle bypass linkages must be engaged
when pushing or pulling the mower. The release
levers are located on each side of the rear of the
unit below the rear engine guard. See Moving
Machine By Hand in the Operation section.
WARNING!
located close to the muffler. To prevent burns,
the engine should be shut off and allowed
to cool before the bypass linkage levers are
handled.
14
Bypass linkages are

Fuel Shut Off Valve

The fuel shut off valve is located at the right rear
of the seat. The valve is off when the handle tab is
turned perpendicular to the fuel line.

Tracking

If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 103 kPa / 15 psi / 1
bar.
1. Tracking adjustments are made using the
tracking bolts. The tracking bolts limit the
motion control levers when in the full-forward
position.
2. For preliminary tracking adjustment, move
unit to an open, unobstructed area such as an
empty parking lot or open field.
3. Using a 1/2" wrench, back the tracking bolts
out until flush with nut.
4. Test operate unit by driving it at full throttle
and the full forward position on both motion
control levers. Gradually turn in the tracking
bolt on the right hand side until the unit
noticeably starts drifting right.
5. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the left tracking bolt until unit
tracks straight.