Bestway 58498 Manual De Instrucciones página 7

Assembly (You will need a screwdriver.)
1. Carefully remove all components
from the package and check to
ensure nothing is damaged. If
equipment is damaged, immediately
notify the retailer from where the
equipment was purchased.
2. The sand filter should be placed on
solid, level ground, preferably a concrete slab. Position
the sand filter so the Ports and Control Valve are
accessible for operation, servicing and winterizing.
3. The sand filter must be vertically fixed on ground or a
certain pedestal made of wood or concrete before use to
prevent the sand filter from accidentally falling. Fully
assembled sand filter will exceed 18 kg. The mounting
holes should be 8 mm in diameter and spaced 86 mm
apart. Use two bolts and nuts with a maximum of 8 mm
in diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand/Flowclear™ Polysphere.
NOTE: Use only special pool-grade filter sand, free of all
limestone or clay: #20 Silica sand 0.45-0.85 mm,
approximately one 9 kg bag should suffice. If you do not
use the recommended size of filter sand, filtering
performance will be reduced and the sand filter may
damaged, thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding
sand, pour some water into the Bottom Tank to submerse
the Skimmer on the Hub.
NOTE: Sand/Flowclear™ Polysphere not
included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to
replace 1 kg (2.20 lbs) sand.
303021216267_58498_14x21cm_1500gal 美规砂滤器说明书-英
Ф8 mm
7
86 mm