Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. INSTALL THE BLOWER (INTERIOR BLOWER) (
Install screws into the location as shown in the pictures below (single blower or dual blower). Do not tighten screws down fully, leave a
1/8" gap. Hang blower unit onto blower plate (screws through the large part of the keyhole). Slide the blower to its position (screws in the
small part of the keyhole). Tighten the screws.
HD0044
Single blower (P5)
Secure the blower by installing 2 more screws into the locations shown in the pictures below (single blower or dual blower). Reinstall
impeller(s) and cover.
HD0080
Single blower (P5)
FOR DUAL BLOWER UNIT, ENSURE THE IMPELLERS ARE
CORRECTLY INSTALLED, THE HOOD WILL NOT WORK
PROPERLY IF REVERSED. Both impellers are different
in the dual blower, one rotates clockwise and the other
counterclockwise. Each wheel and motor have an arrow and
a number on them, you have to match them correctly (see
drawing at right).
Never plug the 2-prong blower cord to the 3-prong power supply cord.
Plug the power supply to the 3-prong male connector (A) and the blower unit into
the 2-prong female receptacle (B) inside the hood.
'
)
CONT
D
HD0045
Dual blower (P8)
HD0081
Dual blower (P8)
1
HD0023
WARNING
!
HE0003
10
FRONT
2
A
B
Publicidad
Tabla de contenido
