Finding Breaks And Opens - Amprobe AT-8000 Serie Guía Rápida

Finding Breaks and Opens

Set-up:
1
Transmitter
Transmitter
indicator showing
signal in
HIGH mode
1. Turn on the Transmitter.
2. Verify that the test leads are properly connected;
the red LED voltage status light should be off for
De-energized circuits below 30 V AC/DC.
3. Select HIGH signal mode by pressing HI.
Tracing a cable to find
breaks or opens
AT-8000-T
TRANSMITTER
BLINKING
HI
LO
©2020 Amprobe
Advanced Wire Tracer - Quick Guide
Set-up:
2
Receiver
1. Turn on the Receiver
and perform tracing
in De-energized
TIP SENSOR mode.
1. Start tracing the cable until the
signal stops.
2. Verify the place of the fault:
move the Transmitter to the other
end of the wire and repeat tracing
from the opposite end. If the signal
stops at the exact same location the
fault has been located.
Note: For best results, ground all
De-energized wires that run in
parallel with the black test lead.
For detailed specifications and ordering go to amprobe.com 6012404 A
®
AT-8000-R
RECEIVER
7