Micronetblink Tests; Flashing The Hub Light Status; Sending A Tone - Fluke Networks MicroNetBlink Guia Del Usuario

M N
ICRO

Flashing the Hub Light Status

1. Set the toggle switch to the Signal position.
2. Plug the 8-position cable (RJ45) into the jack
to be tested.
3. Verify that the
M N
ICRO ET
4. In the wiring closet, view a light that blinks
once every 4 seconds at the port to which the
cable is connected.
M N B
ICRO ET
indicator to assist locating a single channel in a
busy wiring closet.

Sending a Tone

1. Set the toggle switch to the Signal position.
2. Connect the black lead to ground and any
other cable (coax, RJ45, or red alligator) to
the cable to be traced.
3. Press the
activate the toner.
4. Reception of the tone will be loudest (Speaker)
or brightest (LED) on the wire under test.
Caution: Do not connect to an active AC circuit
exceeding 24 V in this mode.
B
ET LINK
button on the face of the
B in the NETBLINK position.
LINK IS
will blink the hub's status
LINK
button to TONE position to
Tests
ENGLISH - 5