Publicidad
Idiomas disponibles
Idiomas disponibles
Once the transceiver (and LED/Valet button if applicable), has
been installed, the remote controls will need to be paired with the
system. See "Remote Pairing" to pair the remote controls with your
system. For more specific programming instructions, please refer
to the programming instructions in your system's owner's guide.
Remote Control Commands
System State
Engine OFF
Engine ON
*This option is only available when using a 4X10.
Note: Please refer to your system's owners guide for more
details on how to use your remote control.
Note: If a feature cannot be activated when performing a
command with the 2-way remote control, a fault tone plays
as an alert.
Start Engine
When the engine is OFF, press and release the remote control
button to start the engine.
Unlock Doors
When the engine is ON with remote start, press and release the
re mote control button. The doors unlock, the parking lights flash
and the horn sounds* (if connected) as confirmation. The 2-way
remote control emits tones.
*This option is only available when using a 4X10.
4
Press/Release button
START ENGINE
UNLOCK DOORS
Press/Hold for 3 sec.
CAR FINDER*
STOP ENGINE
© 2015 Directed. All rights reserved.
Publicidad
