Publicidad
Idiomas disponibles
Idiomas disponibles
Remote Pairing
With a 4X10 :
Use the following procedure to pair an additional or replacement
remote control to the system.
1.
Turn the ignition to the ON position.
2.
Within 10 seconds, press/release once and then press and
hold the control button on the system's control center. The sta-
tus LED begins flashing in a sequence of 1 flash and the horn
sounds to confirm the system is ready for pairing. Release the
control center button.
3.
Press and release the remote control button twice quickly,
and then press and hold it. The transmit LED comes on solid,
continue to hold the button until the transmit LED changes
its pattern. Release the button and the transmit LED begins
flashing as an indication that the remote has entered the
pairing mode.
4.
Press and release the button on the remote control.
5.
The horn sounds as a confirmation the system has paired
with the remote control and the 2-way remote plays tones
confirming that the remote has paired with the system (the
1-way remote does not offer confirmation tones). The remote
will automatically exit the pairing mode after 30 seconds
or you can manually exit the pairing mode by pressing and
holding the button on the remote, the remote will emit a tone
confirming exit. If pairing fails repeat steps 3 - 6.
6.
Turn the ignition off or wait 60 seconds for the system to exit
the pairing mode, the horn will sound as confirmation.
6
© 2015 Directed. All rights reserved.
Publicidad
