Publicidad
Idiomas disponibles
Idiomas disponibles
With an Xl202 :
1.
Press the button on the remote control twice and then hold on
the third press. The transmit LED will come on solid, continue
to hold the button until the transmit LED changes its pattern.
Release the button and the transmit LED will begin flashing as
an indication that the remote has entered the pairing mode.
2.
Press and hold the programming button of the XL202 mod-
ule. The LED will begin flashing slowly (Do Not Release the
XL202 Programming Button).
3.
Press the button on the remote control. The LED on the XL202
will turn on solid for one second, then LED then turns off to
indicate that pairing was completed successfully. If Remote
Pairing fails repeat the above procedure or confirm the firm-
ware flashed to the XL202 is correct for the type Antenna/
Remote you are using.
Note: The 2way remote will play tones confirming that the
remote has paired with the system.
4.
Release the programming button on the XL202.
The programming routine exits if any of the following occurs:
•
The ignition is turned off
•
There is no activity for 30 seconds
•
The Control Center button is pressed too many times
© 2015 Directed. All rights reserved.
7
Publicidad
