KTM Power Parts 76008915144 Instrucciones De Montaje página 5

22
24
25
23
26
18
8
5
17
Scope of supply (see Figure C):
2x EJOT PT screws K60x30-Z SW6 (1)
2x washers DIN9021 - A 6.4 (2)
1x washer DIN0125 - A 5.3 (3)
3x oval head screws ISO 7380 - M6x18 (4)
1x cap head screw DIN912 - M5x14 (5)
1x hexagon nut DIN985 - M5-A2 (6)
3x hexagon nuts DIN985 - M6-A2 (7)
2x countersunk screws DIN7991-M4x8 (8)
5x cable sleeves D=8 (9)
2x bushings 4.2x12x8.5 (10)
4x screws M8x20 (11)
5x bushings (12)
1x adhesive guide (13)
1x subframe (14)
1x tail light holder (15)
1x license plate support (16)
1x license plate light adapter (17)
1x brace (18)
1x tail light (19)
1x license plate light (20)
1x retaining belt (21)
Preparations
- Remove the passenger seat (22).
- Disconnect the turn signal, license plate light, and tail light (Figure A).
- Remove the screws (23) and take off the handles (24).
- Repeat the procedure on the other side.
NOTE:
A
Carefully set down the original license plate holder (25).
Assembly
- Assemble the license plate holder (see Figures B and C):
- Insert the cable sleeves (9) into the license plate support (16).
- Insert the left and right bushings (12) into the cable sleeves from the inside
and the upper bushing into the cable sleeve from the top.
- Position the brace (18) as shown and attach it with the screws M6x18 (4)
and nuts M6 (7).
15
7
NOTE:
In hole D, the brace must be screwed onto the license plate frame and the
D
license plate panel.
B
10
6
16
11
13
14
7
18
21
0017060303
0021060003
0125050003
0738060181
0912050143
0985050003
0985060003
0991040083
31008060000
69013076000
69014015000
69015019020
78014040000
61314947000
76007947030
9
15
2
1
C
5