Yakima HoldUp Manual Del Usario página 3

Fold holdup down.
prepare For loadIng.
Release wheelstrap
by pressing the lever
on the buckle.
Tuck strap into
slot at rear of
whelltray.
swIng pIvot arm Into place.
Rotate the pivot arm
up until the hook
rests on the bike tire
1" from the brakes.
1033533E-3/15
• Pull spring pin to
release base.
• Fold down holdup
• Release Pin. Pin should
snap into place.
load heavIest BIKe FIrst.
note: Holdup can fold down past
horizontal to aid in loading your bikes.
be sure to return the holdUp to the locked
horizontal position after loading.
CAUTIoN: If any part
of your bike comes in
contact with the red
trigger, do not use this
carrier with that bike.
Not for use on bikes
with front fenders.
Fold pIvot arm down.
be sure pivot arm
is folded down.
Make sure your tires are
filled to recommended
pressure found on the tire.
secure the hooK.
Compress the
hook against
the wheel by
applying firm
pressure.