Yakima HoldUp Manual Del Usario página 4

secure rear wheel strap.
Feed the strap through the spokes of wheel.
alwaYs use Your locKIng caBle
when transportIng BIKes.
Pass the locking cable through
your bike frames and quick-
release wheels. Pass lock
through loop at end of cable.
Also availiable (sold seperately):
hITChLoCK (yakima part number
8007235) for locking the hitchbolt to
secure your Holdup from theft.
secure pIvot arms when not In use.
when not carrYIng BIKes alwaYs Fold holdup up.
Fold wheeltray
Slide the hook
against the rear
wheel cradle.
read all warnIngs on neXt page BeFore drIvIng awaY.
1033533E-4/15
Rotate the wheel
slightly, if necessary.
lock it at the
mast pivot point.
• Remove hitch pin and lock to the hitch bolt.
• Check engagement by pulling on lock.
• IMPoRTAnT: Hitch pin must always be
used when the bike lock, or hitch lock are
not used!
inboard.
tIghten rear wheel strap.
• Insert the
strap end
through
the top of
the ratchet
buckle.
• be sure the
pad rests on
the rim.
oR
Tilt wheeltray
inboard.
Fold up holdUp.
Move the ratchet tab up and
down to tighten the strap.
checK the
InstallatIon
BeFore drIvIng
awaY.
• PUSh hooKS AGAINST TIRES.
• REAR whEELS SECURED bY
RATChET STRAPS.
• bE SURE ALL hARDwARE IS
SECURED ACCoRDING To
INSTRUCTIoNS.
• ALwAYS SECURE PIVoT ARm
whEN TRAY IS EmPTY.
Rotate pivot
arm down.