Safety Warnings; Features - Surtek CSS01 Manual De Usuario Y Garantía

SAFETY WARNINGS

The Solar-Powered Auto-Darkening Welding
Helmet is suitable for most welding applica-
tions. This helmet's 1 / 25,000-second switch time
automatically darkens the lens the moment you
start welding. No matter what shade the filter
is set to, the UV/IR protection is always present.
• ARC Rays can
injure eyes and
burn skin
- Before weld-
ing, always in-
spect helmet and
Auto-Darkening
Filter (ADF) to be
sure they are fit-
ted properly and
in good condition.
- Keep the sensors, solar cell and filter lens clean.
Clean the filter cartridge using a soap water
solution and soft cloth. Do not use solvents or
abrasive cleaning detergent.
- Do not weld in the overhead position while us-
ing this helmet.
- Inspect the filter lens frequently and immedi-
ately replace any scratched, cracked, or pitted
filter lens or cover lenses.
- Always wear safety glasses or goggles under
the welding helmet, and protective clothing
to protect your skin from radiation, burns and
spatter.

FEATURES

1
2
6
5 6
KNOW YOUR TOOL
Helmet
1. Helmet Shell.
2. Protective plate + front cover lens.
3. Protective plate buckle.
4. Headgear angle adjusting knobs.
ADF (inside of helmet)
5. ADF self-check.
6. Internal variable shade control.
7. Dial knob sensitivity control (low to high).
4 8. Delay control knob.
9. Battery change.
10. Low voltage indicator.
11. Grinding function.
3
12. LCD.
ADF (outside of helmet)
13. Solar Panel.
14. Arc Sensors.
15. UV/IR Filter.
7 8
11
10
12
13
15
9
14