Technical Data; Operation Instructions - Surtek CSS01 Manual De Usuario Y Garantía

TECHNICAL DATA

CSS01
OPTICAL CLASS
VIEWING AREA
FRONT COVER LENS
INSIDE COVER LENS
ARC SENSOR
LIGHT STATE
DARK STATE (VARIABLE SHADE)
UV/IR PROTECTION
SWITCHING TIME
DARK TO LIGHT
LOW AMPERAGE TIG
OPERATING TEMPERATURE
STORING TEMPERATURE
1 CR2450 LITHIUM BATTERY INCLUDED

OPERATION INSTRUCTIONS

• HEADGEAR ADJUSTMENT
1. Adjust the headgear diameter with the twist
knob on the back. The knob is unlocked until
pushed in. Once unlocked, twist clockwise to
tighten and counterclockwise to loosen.
2. To adjust the distance between the user's face
and ADF, loosen the outside tension knobs to
allow for headgear to be repositioned to a di-
fferent location. This should be done one side
at a time and both sides should be located the
same for proper auto-darkening filter opera-
tion.
3. To adjust the viewing angle, loosen the knob
and push the helmet forward and back to the
desired tilt position. Once the angle is correct,
tighten the knobs until snug. The helmet should
still swing up, but it should not drift downward
when in place for welding.
4. Adjust the height by snapping the pin into
the hole to lock securely in place.
• SELF-CHECK
Press the TEST Button anywhere to see if it au-
tomatically switches to dark state and release it
to check that the filter returns to the light state.
• SHADE CONTROL/GRIND MODE
Select the shade 9 to 13 based upon the welding
process you will use by consulting the "Shade
Guide Table". The variable shade control knob
is near inside cover lens for internal adjustment.
1 / 2 / 1 / 3
98 X 43 mm
109,6 x 86 x 1 mm
103,6 x 48,8 x 0,8 mm
2
DIN 4
9 - 13
DIN 16
1/ 250000s from light
to dark
0.1- 1.0 S by infinitely
dial knob
≥5 amps (CD/DC)
≥5 amps (CA/AC)
-5 ºC ~ +55 ºC
-20 ºC ~ +70 ºC
E N G L I S H •
The welding helmet can also be used to protect
the face when grinding. Grind mode prevents
filter lens from auto-darkening.
• DELAY CONTROL
When welding ceases, the viewing window au-
tomatically changes from dark back to light but
with a pre-set delay to compensate. The delay
time can be set to MIN (0.1 sec) or MAX (1.0 sec),
by infinitely dial knob inside the cartridge. The
minimum delay suits spot or short welds. The
maximum delay suits heavy current welding
and reduces eye fatigue from the arc. Selections
between MIN and MAX are suitable for most of
indoor and outdoor welding operations.
• SENSITIVITY CONTROL
The sensitivity can be set to LOW or HIGH by
using the infinitely dial knob on the back of the
cartridge. The LOW setting suits excess ambient
light or with another welding machine close by.
The HIGH setting suits low amperage welding
and welding in areas with low light conditions,
especially low amperage argon arc welding. Se-
U s er 's M an u al
1 4 4
2
3
7