Add Engine Oil - Briggs & Stratton Generac 2700PSI Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray.
• Place the handle assembly onto the handle supports
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure 2).
Figure 2 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the "L" bolt through the hole on the left side of
the handle (viewing from handle side of unit) and attach
the plastic knob.Tighten the knob by hand (Figure 3).
Figure 3 — Secure Handle
• Insert the carriage bolt through the right side hole from
the outside of the unit and attach a plastic knob from the
inside of the unit (viewing unit from the handle side).
Tighten by hand (Figure 3).
• Insert the "J" hook into the second from the left slot in
the accessory tray (Figure 4).
Figure 4 — Install "J" Hook on Accessory Tray
Generac 2700 PSI Pressure Washer
Handle
Handle
Supports
• Pinch the chemical hose and slide it into the metal clip as
shown in Figure 5.
Figure 5 — Slide Chemical Hose into Metal Clip
• Tilt the unit up by the handle and attach the metal clip to
the rib on the center underside of the accessory tray
(Figure 6). Slide the chemical hose through the metal clip
so that it is tight but not kinked.
Figure 6 — Slide Metal Clip onto Accessory Tray Flange

Add Engine Oil

IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Add Gasoline
WARNING!
fill fuel tank when engine is running or hot. Allow
unit to cool for two minutes before refueling. DO
NOT light a cigarette or smoke when filling the fuel
tank.
6
NEVER fill fuel tank indoors. NEVER

Publicidad

Tabla de contenido
loading

Tabla de contenido