Checklist Before Starting Engine; Operation - Briggs & Stratton Generac 2700PSI Instrucciones De Uso

Checklist Before Starting Engine

Review the unit's assembly to confirm you have performed
all of the following:
• Make sure the handle is in place and secure.
• Check that oil has been added to the proper level in the
engine crankcase.
• Add the proper gasoline to fuel tank.
• Check for properly attached hose connections.
• Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
• Provide a proper water supply at an adequate flow.
• Be sure to read "Safety Rules" and "How To Use Your
Pressure Washer" before using the pressure washer.
HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-270-1408.
To Start Your Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
• Place the pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.5 gallons per minute and no less than 20 PSI at the
pressure washer end of the garden hose.
• Check that the high pressure hose is connected to the
spray gun and to the pump. See "Preparing Pressure
Washer for Use" for illustrations.
• Make sure unit is in a level position.
• Connect the garden hose to the water inlet on the
pressure washer pump. Turn ON the water.
CAUTION!
DO NOT run the pump without the water
supply connected and turned on.You must follow this
caution or the pump will be damaged.
• Squeeze the trigger on the gun until you have a steady
stream of water.This purges the pump of air and
impurities.
Generac 2700 PSI Pressure Washer
• Attach the nozzle extension to the spray gun (Figure 11).
• Choose the spray tip you want to use and insert it into
• Engage the safety latch to the spray gun trigger (Figure 12).
• Rotate the fuel shut-off valve to the "On" position (fully
• Move the variable pressure control lever to "High"
8
Tighten by hand.
Figure 11 — Connect Nozzle Extension to Spray Gun
the nozzle extension. See "How to Use the Spray Tips"
on page 10.
Figure 12 — Spray Gun with Safety Latch Engaged
counter-clockwise) (Figure 13).
Figure 13 - Fuel Valve
Fuel Valve shown in
"On" position
position, shown on engine as a rabbit (Figure 14).
Figure 14 - Variable Pressure Control Lever
Safety Latch