How To Use The Spray Tips - Briggs & Stratton Generac 2700PSI Instrucciones De Uso

How to Use the Spray Tips

CAUTION!
NEVER exchange spray tips without
locking the safety latch on the trigger.
The quick–connect on the nozzle extension allows you to
switch between five different spray tips.The spray tips vary
the spray pattern as shown below (Figure 17).
Follow these instructions to change spray tips:
• Engage the safety latch on the spray gun.
• Pull back the collar on the quick–connect and pull the
current spray tip off. Store the spray tips in the space
provided on the handles storage panel.
NOTE: For a more gentle rinse, select the white 40° or
green 25° spray tip.To scour the surface, select the yellow
15° or red 0° spray tip.To apply chemical, select the black
spray tip.
• Pull back on the collar, insert the new spray tip and
release the collar.Tug on the spray tip to make sure it is
securely in place.
• For most effective cleaning, keep the spray tip from 8 to
24 inches away from the cleaning surface. If you get the
spray tip too close, you may damage the cleaning surface.
• DO NOT get closer than 6 inches when cleaning tires.
Figure 17 — Spray Tips
Low Pressure
Use to
apply
chemical
Black
Generac 2700 PSI Pressure Washer
White Green
40°
Cleaning and Applying Chemical
CAUTION!
You must attach all hoses before you
start the engine. Starting the engine without all the hoses
connected and without the water turned ON will damage
the pump.
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent follow these steps:
• Review the use of the spray tips.
• Prepare the detergent solution as required by the
manufacturer.
• Hang the detergent solution on the "J" hook attached to
the accessory tray, as shown in Figure 18.
Figure 18 — Insert Filter into Container
High Pressure
25°
10
Yellow
15°
Red
0°