The Display - klover PB 35 Instalación, Uso Y Mantenimiento, Consejos Útiles

THE DISPLAY

The equipment's functioning state is displayed by the console. Many types of displays and the available settings based on the selected menu can be made
by accessing the menu.
The following figure shows the display in equipment on or off conditions.
1
2
1
2
The following figure describes the meaning of the state signals on the display's left wall (1st LED SERIES).
ROOM THERMOSTAT: the LED is on when room thermostat contact is open.
CHRONO-THERMOSTAT: the LED is on when at least one ignition and switch-off program is active.
IGNITION RESISTANCE: the LED is on when ignition resistance is active.
SCREW FEED: the LED is on when the pellet load motor reducer switches on.
FLUE GAS EXTRACTOR: the LED is on when the flue gas intake device is active.
DHW FLOW SWITCH: the LED is on when DHW flow switch contact is closed (DHW is requested).
PUMP: the LED is on when system circulation pump is active.
!
ALARM: the LED is on when the boiler is in alarm state.
Meaning of the state signals is found top-right of display (2nd LED SERIES).
2 3
1
4 5 6
1 – the LED is on when the chrono-thermostat's daily program is active.
2 – the LED is on when the chrono-thermostat's weekly program is active.
3 – the LED is on when the chrono-thermostat's week-end program is active.
4 – the LED is on (flashing) when the functioning parameters are being modified.
5 – the LED is on when the summer function is active (currently unused).
6 – the LED is on when the winter function is active.
7 – the LED is not currently used.
CLOCK
17:19
- - - -
Set
OFF
3
!
DIALOGUE
1st LED
SERIES
Set
3
!
7
ROOM TEMPERATURE (optional)
C
60°
WATER TEMPERATURE
2nd LED
SERIES
14
6
4 5
6
5
4