Reading Stored Test Results From Memory; Understanding Your Test Results - HMM Diagnostics smartLAB mini Manual Del Usuario

Reading stored test results from memory

You can read the last 20 test results on the internal memory of your
smartLAB
® mini meter by inserting the check strip. The results will
be shown chronologically on the display.

Understanding your test results

The smartLAB
pro blood glucose test strips are whole-blood ref-
®
erenced. Your meter is plasma-calibrated for easier comparison to
lab results. The unit of blood glucose test results displayed on the
screen is either mg/dL or mmol/L, depending on which unit of
measurement you have selected. The mmol/L results will always in-
clude a decimal point; mg/dL results do not include a decimal point.
If „LO" appears on the display, the monitor has determined that
your blood glucose level is lower than 1.1 mmol/L or 20 mg/dL. If
„HI" appears on the display, the monitor has determined that your
blood glucose level is higher than 35 mmol/L or 630 mg/dL. Please
refer to the User Manual for instructions on warning messages.
Expected results for non-diabetic adults:
The normal fasting glucose range is 70 to 100 mg/dL (3.9 to 6.1
mmol/L). Two hours after meals, normal glucose values should be
less than 120 mg/dL (6.7 mmol/L).
Unusual test results:
If your blood glucose result doesn't match the way you feel, follow
these steps, and then repeat the test:
1. Check if the strips are within the expiration date.
20