Watts BT DP-01 Guía De Usuario página 36

to confirm.
The message "Yes" should be displayed; the value will
be stored in the internal memory.
If you need to erase a calibration press on the escape
key (
The old value will be erased and the message "no" will
be displayed.
* Pay attention:
Only the heating element driven by the thermostat must
be used during the complete step of the calibration.
OutC , AMbC , FlrC: Calibration of the external
05
wired probe
Same calibration method as described in parameter
"04 AirC" above.
HG: Anti-freeze temperature used in Holiday mode
06
Default value 10°C.
Use the (-) or (+) keys to change the anti-freeze setting
temperature. Then press (Ok) to confirm.
ITCS: YES, no
07
The Intelligent Temperature Control System will
activate your installation in advance (2 hours
maximum) to assure the desired temperature at the
).
36