Tiller Operation - Yaros 650 Manual Del Usuario

7. TILLER OPERATION

1. Handle height adjustment
WARNING Before making any adjustments, place the
machine on a flat surface to prevent accidental dropping
of the handlebar. To adjust the height of the handlebar, loosen the
adjusting device, select the most appropriate holes and tighten
again.
2.Depth Regulation
Insert the hitch into the box using the bolt provided. The depth
adjustment can be carried out as follows:
Remove the bolt and the locking pin, loosen the locking bolt of the
drawbar and slide the bar upwards or downwards.
(1) Tool holder (2) Hitch pin
(3) Locking Pin (4) Drawbar (5) Bolt
3. Clutch operation
The clutch engages or disengages the engine power for transmis-
sion. When the clutch lever is pushed, the clutch is engaged and the
power is transmitted. Tighten the lever.
The milling cutter begins to rotate. When the lever is released, the
clutch disengages and the power transmission stops. When the
clutch lever is released, the cutter stops.
WARNING reduce engine speed before operating the
main clutch.
(1) Clutch lever (2) Clutch (3) Clutch release
4. Gear switching
The transmission can move to the second gear forward.
The gear lever must be operated according to the gear change plate.
Gearshift:
1. Move the gas lever all the way to the right.
2. Release the clutch lever to disengage.
3. Move the shift lever to the desired gear position.
NOTE: If the gear lever does not engage the desired gear, tighten
the clutch lever and slightly move the axle to reposition the gears.
4. Tighten the clutch lever.
5.Select the speed
The motorcycle has three speeds to choose from:
(1) Adjustment mechanism
6. Using a tool holder
Install the hitch in the box with the bolt provided.
7. Front wheel
Use the front wheel to move the motorcycle on the road. Lift the
handlebar and lower the wheel until it touches the ground.
When using the tractor in the field, raise the wheel to replace the
fixing bolt.
22
Conversion of speeds:
(1) Set the throttle to the right.
(2) Release the clutch handle and let
the clutch release.
(3) Set the shift lever to the desired
speed.
(4) Pressing on the clutch handle, the
engine moves to the new speed.
FAST - DEAD POINT - SLOW
(1) Tool box
(2) Stud bolt
(1) Working condition in the field
(2) Fixing bolt (3) Road disassembly
EN