Publicidad
20mm SKEWER TUBE
INVENTORY
15mm SKEWER TUBE
REAR STRAP
U-BOLT (2)
SECURITY NUT (4)
REAR STRAP BOLT (2)
REAR STRAP KNOB (2)
CROSS BAR STRAP
9mm SKEWER
PRE-INSTALLED
MOUNTING RANGE
MAXIMUM CROSS BAR THICKNESS
MAXIMUM CROSS BAR WIDTH
43mm or 1.7"
MOUNTS TO VEHICLE CROSS BARS AS THIN AS 15mm or 0.6"
ROOF BAR MOUNTING RANGE
500mm TO 1275mm
19-5/8" TO 50-3/16"
SKEWER/AXLE INSTALL
SKEWER TUBE WRENCH
20mm & 15mm AXLE MOUNT
Use skewer tube wrench to remove 9mm
skewer. Turn left to loosen. When loose,
pull out 9mm skewer and insert 20mm or 15mm
axel to noted insert line. Turn skewer tube wrench to
U-BOLT WRENCH
KEY (2)
SKEWER TUBE WRENCH
BOTTLE OPENER
ROOF RACK
MOUNTS TO FACTORY
AND AFTERMARKET
ROOF CROSS BARS
90mm or 3.5"
The 9mm skewer can be installed
from either side of the vehicle you
are mounting the rack.
FRONT VEHICLE RACK MOUNTING
BURLAP BAG
REAR VEHICLE RACK MOUNTING
ROUND
SQUARE
OVAL
AERO
REAR CROSS BAR INSTALL
Slide rear strap bolts into"T" slot on bottom of Rüfee rack. Place
cross bar strap over strap bolts and thread on knobs by hand.
REAR STRAP INSTALL & USE
FRONT CROSS BAR INSTALL
Hand thread all security barrel nuts prior to using 5 sided security wrench.
Alternate tightening of each barrel nut until tight. WARNING: Excessive
overtightening may dent vehicle cross bar.
BOTH SIDES OF BIKE STRAP CAN
BE ADJUSTED TO PREVENT
CONTACT WITH VEHICLE ROOF
SLIDE STRAP THROUGH REAR
SLIDING CRADLE ON RACK. STRAP
ADJUST STRAP CRADLE TO BE
CAN BE INSERTED FROM EITHER SIDE.
CENTERED UNDER REAR TIRE
1
2
Publicidad
