Kenmore 405.84126 Manual De Uso página 22

SWING OPERATION
Use the SWING button to adjust the Up/Down airflow direction.
I. Press this button to begin continuous up and down swinging of fan louver door. Press again
to fix louver door into one position. NOTE: When the louver swings or moves to a position
which would adversely affect the cooling effect of the air conditioner, it will automatically
change the swing moving direction or position to prevent a problem.
TIMER OPERATION
Pressing the TIMER ON button will set the Auto-on time of the unit. Pressing the TIMER OFF
button will set the auto-off time of the unit.
TO SET THE AUTO-ON TIME:
1. Press the TIMER ON button. The remote controller shows TIMER ON, the last Auto-on setting
time and the symbol "h" will be shown on the LCD display area. Now it is ready to set the Auto
-on time to START the operation.
2. Push the TIMER ON button again to set desired Auto-on time. Each time you press the button,
the time increases by half an hour between 0 and 10 hours, and by one hour between 10 and
24 hours.
3. After setting the TIMER ON, there will be a one second delay before the remote controller
transmits the signal to the Air Conditioner. Then, after approximately another 2 seconds, the
symbol "h" wilt disappear and the set temperature witl re-appear on the LCD display window.
The set temperature will not appear in FAN mode.
TO SET THE AUTO-OFF TIME
1. Press the TIMER OFF button. The remote controller shows TIMER OFF, the last Auto-off setting
time and the symbol "h" will be shown on the LCD display area. Now it is ready to set the Auto-
off time to STOP the operation.
2. Push the TIMER OFF button again to set desired Auto-off time. Each time you press the button,
the time increases by half an hour between 0 and 10 hours, and by one hour between 10 and 24
hours.
3. After setting the TIMER OFF, there will be a one second delay before the remote controller
transmits the signal to the Air Conditioner. Then after approximately another 2 seconds, the symbol
"h" wilt disappear and the set temperature wilt re-appear on the LCD display window. The set
temperature wilt not appear in FAN mode.
TO CANCEL AUTO TIME
1. Press the TIMER CANCEL button to cancel the auto time.
22