LOCATION
The Air Conditioner should be placed on a firm
foundation to minimize noise and vibration. For safe
and secure positioning,
place the unit on a smooth,
level floor strong enough to support the unit.
The unit has casters to aid placement,
but it should
only be rolled on smooth, flat surfaces. Use caution
when rolling on carpet surfaces. Do not attempt
to
roll t heunit over objects.
The unit must be placed within reach of a properly
rated grounded
socket.
Never place any obstacles around the air inlet or
outlet of the unit.
Allow 12" to 40" of space from the wall
for maximum
performance.
WINDOW
SLIDER INSTALLATION
Your window
slider has been designed
to fit
most standard
vertical
and horizontal
window
applications.
However, it may be necessary
for you to modify
some aspects of the installation
procedures
for certain
types of windows.
Refer to
Fig. 6 and Fig. 7 for minimum and maximum
window
openings.
Once window
slider is opened
to correct
width,
insert supplied
screw to fix in place
(see Fig. 7a).
NOTE: If the window
opening
is less than the
minimum
length of the window
slider, only use
the window
slider section
with the hole. Cut from
the end that is furthest
from the section
hole.
Do not cut any material
from the end that is
nearest
hole.
A: 12"-40"
B:- 12"
Fig.5
I[[
Vertical
Window
4
€
Window
Slider
Minlmum:26.57
Inch(67.Scm)
Maximum:
48.431nch(123cm)
Fig,6
Vertical
_-
Window
•'
0
Window
Slider
Minlmum:26.57
I
,(67.5cm)
Maximum:
48.43
(123cm)
Fig,7
Bolt
Window slider sections
Fig,7a