Blaupunkt EMA 260 Manual De Instrucciones página 6

EMA 260
Stereo Mode
RMS.power
Mono mode
RMS.power
Stereo Mode
RMS.power
RMS power in accordance with CEA-2006
(<.1%.dist../.+14.4V)
Frequency
response
Signal-to-noise ratio
Signal-to-noise ratio
Distortion factor (RMS)
Stability
Input sensitivity
Low-pass filter
(Low.Pass)
High-pass filter
(High.Pass)
Bass boost
Dimensions
W.x.H.x.D.(mm)
W.x.H.x.D.(")
Plus / minus connection
-. We.recommend.a.minimum.cross.section.of.6.mm
-. Route.commercially.available.plus.cables.to.the.
battery.and.connect.via.fuse.holder..
-. Use.cable.glands.for.holes.with.sharp.edges..
-. Securely.fasten.commercially.available.minus.cables.
to.a.noise-free.earth.point.(chassis.screw,.chassis.
metal).(not.to.the.minus.pole.of.the.battery)..
-. Scrap.the.contact.surfaces.of.the.earth.point.until.
they.are.bright.and.grease.with.graphite.grease.
Integrated fuses (Fuse)
The.fuses.integrated.in.the.amplifier.(Fuse).protect.the.
power.amplifier.and.the.entire.electrical.system.in.case.
of.an.error..If.a.replacement.fuse.is.used,.never.bridge.
fuses.or.replace.them.with.a.type.with.higher.current.
Connection examples
Connection.of.the.voltage.supply.
Connection.to.car.sound.system.with.
cinch.output..
Loudspeaker.connections..
Note:
To.avoid.damaging.the.amplifier.in.operation,.all.loud-
speaker. connections. must. be. occupied. according. to.
Fig..4,.5,.6..
6
.x.55.Watt./.4.Ω Fig..4,.5.
1.x.160.Watt./.4.Ω Fig..6
.x.80.Watt./..Ω Fig..4,.5.
10.Hz.-.5.000.Hz
>.90.dB.@.RMS.power
>.73.dB.@.1.W./.1kHz
<.0.05%
.Ω.(4.Ω.in.bridge.mode)
0.3.–.8.V
50-50.Hz
50-50.Hz
0.dB.to.+1.dB
30.x.56.x.00
9.1.x...x.7.9
Fig..
Fig..3
Fig..4/5/6
+12V
.
Remote.connection.of.the.amplifier.with.switchable.+1.V.
voltage.source.
This.allows.the.amplifier.to.be.switched.on.and.off.using.
the.on/off-switch.of.the.radio.device.
Level control
The.Level.control.is.used.to.adjust.the.input.sensitivity.
of.the.power.amplifier.to.the.output.voltage.of.your.car.
sound.system.preamplifier.output.
The.adjustment.range.is.from.0.3.V.to.8.V..
If.a.car.sound.system.of.a.third.party.manufacturer.is.
connected,.the.input.sensitivity.must.be.adjusted.cor-
responding.to.the.manufacturer.data.
A few important explanations in this context:
By.turning.the.control.clockwise,.the.input.sensitivity.of.
the.amplifier.and,.therefore,.also.the.volume.increases..
However,.this.is.not.a.volume.control;.no.further.ampli-
fier.output.can.be.achieved.in.the.end.position,.even.if.it.
may.sound.like.that.at.the.beginning..The.system.merely.
increases.the.volume.faster.if.the.volume.control.of.the.
car.sound.system.is.turned.up.
Loudspeaker connections
(If.the.amplifier.is.to.be.jumpered,.continue.with.the.sec-
tion."Bridged.loudspeaker.connections".at.this.point).
As. with. every. audio. component,. the. correct. polari-
sation. of. amplifier. and. loudspeakers. is. of. essentially.
importance.for.a.good.bass.response..For.this.reason,.
ensure.that.the.positive.(+).connection.of.the.amplifier.
is. connected. with. the. positive. connection. (+). of. the.
loudspeaker;.the.same.applies.to.the.negative.(-).con-
.

nections.. In. addition,. the. left. amplifier. channel. must.
be. connected. with. the. left. loudspeaker. and. the. right.
amplifier.channel.with.the.right.loudspeaker.
Bridged loudspeaker connections
The. EMA. amplifier. can. also. be. bridged. for. a. mono.
configuration..This.allows.the.amplifier.to.be.used.for.
one.or.several.subwoofers.or.mid-range.drivers..In.this.
configuration,.the.amplifier.combines.the.right.and.left.
channel.to.a.single-channel.output.(mono.output).
Note:
The.amplifier.can.add.the.right.and.left.signal.informa-
tion.only.if.the.right.as.well.as.the.left.RCA.connection.
were.carried.out.
Caution:
In a bridge circuit, the amplifier load must be 4 ohm
or higher. A lower load leads to an overheating or
switch-off of the amplifier and can cause permanent
damages.
Adjusting the type and range of the frequency
crossovers
With.the.EMA.60,.the.type.of.frequency.crossover.(i.e..
"Low.Pass".or."Hi-Pass").and.the.desired.entry.frequency.
can.be.adjusted..For.example,.if.a.pair.of.subwoofers.is.to.