Publicidad
SMART
PADDLE
The fully electronic paddle sensor. This capacitive level sensor is designed for the level control of bulk
materials with a dielectric constant (DC) of e
It is media optimised and pre-adjusted.
An adjustment for the product to be detected is simply not necessary.
Please just do an adjustment, if the dielectric constant of your medium is outside the preset range.
It could not be easier.
Mount
o o u u u u u
un
an n
an
and
nd
The user mounts the sensor, makes the electrical connection and the
G
G
G
G
Go
sensor is ready for use.
Because of the special design, the
SMARTPADDLE
position you require (fig. 1). The front surface is not active (fig.2).This means, that the
can touch the wall of the pipe without affecting the measurement (fig.3).
Fig. 1
Listed Component Conforms to UL Std. 61010-1
Certified to Can/CSA Std. C22.2 No. 61010-1
02.2018
For use in class 2 circuit only
79002207
Uniquement pour utilisation dans circuits classe 2
2 to 80.
r
is very easy to mount. You can mount it in any
Fig. 2
Inactive surface
Fig. 3
Please pay attention, when mounting the
i
SMARTPADDLE
into a pipe that the
sensor does not obstruct the flow.
www.rechner-sensors.com
e-mail: info@rechner-sensors.de
3110580
Tightening torque
In order to prevent damage to the threaded
sleeves when mounting the SMARTPADDLE,
the maximum torque should be taken into
consideration. Maximum torque = 20 Nm
Pin connection for pluggable sensors (top view)
SMARTPADDLE
Potentiometer
4
1
Electrical connection
Connection diagram with potentiometer
Connection diagram with ETW-function
RECHNER Industrie-Elektronik GmbH
Gaußstraße 8-10 · D-68623 Lampertheim
Tel. +49 6206 - 5007-0 · Fax +49 6206 - 5007-20
ETW
3
3
4
5
2
2
1
Publicidad
