Skil LT4818-00 Manual Del Propietário página 18

Line Replacement
NOTICE: Always use the recommended
nylon cutting line with a diameter that does
not exceed 0.080 in. (2.0 mm). Using line
other than that specified may cause the string
trimmer to overheat or become damaged.
WARNING
rope, etc . These can break off and become
dangerous projectiles .
WARNING
the battery pack from the tool before
servicing, cleaning, changing attachments
or removing material from the unit .
1. Remove the battery pack from the trimmer.
2. Cut one piece of cutting line 16 ft. (5m)
long. Insert the line into the eyelet. Push
the line until the end of the line comes
out of the other side of the trimmer head.
Pull the line from the other side until equal
amounts of line appear on both sides
(Fig. 15).
3. Hold the lower cover and rotate the shroud
in the direction indicated by the arrow to
wind the cutting line into the trimmer head
until approximately 5.1 in. (13cm) of line is
showing on each side(Fig.16).
4. Push down on the trimmer head while
pulling on the lines to manually advance
the line and to check for proper installation of the cutting line.
18
Never use metal-
reinforced line, wire, or
To prevent serious
personal injury, remove
Fig. 15
Eyelet
Fig. 16
Shroud
Arrow
Direction
5.1'' (13cm)
Lower
Cover