Tabla de contenido
Publicidad
PREPARING THE FIXTURE
FOR INSTALLATION
Remove fi xture components and parts pack(s). Check that all
parts are included. See Page 3.
Note: A single unit or the fi rst unit in a chain is capable of being direct-wired
to incoming power or use the optional power-cord to supply power.
You will need to determine which method prior to installing the product. If
multiple units are to linked together (max. 345 Watts), the suppliled row
connector or the optional linking cords will be required.
Also- Per Regulartory requirements, one connector port is "Keyed". To
insure proper installation of multiple units- Make sure all fi xtures are ori-
ented in the same manner.
Note: Turn off power at circuit breaker box!
Direct-Wire Method
1. Remove LED Cover Assembly (2) by lifting upward on exposed
edges of part. Start in the middle and work outward.
Disconnect Wire connecters (4) from LED Cover Assembly (2) and
Housing Assembly (1).
2. Determine appropriate knockout for removal in relationship to
incoming power supply. (Knockouts are located on back of the fi xture.)
To remove knockouts:
Place standard screwdriver on edge of circle (on opposite side from
retaining tabs) and gently strike with hammer. Grip edge with pliers and
fl ex back and forth until removed. See Fig. 1.
3. If using romex strain relief bushing, install the bushing into the open
hole.
4.
Insert house power supply cable through open hole or strain relief
bushing.
5.
Position the Housing Assembly (1) against the mounting surface
and with a pencil, mark the screw hole locations to be located at the nar-
row section of the keyholes. See Fig. 2.
6.
Using a drill with a 1/16" drill bit, make two small pilot holes at the
marked screw hole locations. If drill bit does not encounter a stud or wood
surface, use toggle bolts or suitable fastener depending on structural
conditions. If drill bit does encounter wood surface, use provided #10 wood
screw (10).
7.
Partially install the Mounting Screws. Position the Housing As-
sembly (1) against the mounting surface with the screw heads through the
keyhole mounting holes. Slide the fi xture until the screw heads are through
the narrow section of the key holes. Finish tightening the screws to secure
the fi xture against the mounting surface.
WIRING AND FIXTURE OPERATION CAUTION:
Connect fi xture to supply wires rated for at least 90°C (194°F).
8.
Cut supply cable to desired length. Strip black and white wire leads
with wire strippers to expose 3/8"-7/16" of bare metal.
See Fig. 3.
9. Connect supply (house) wires to fi xture wires, push stripped wires
into appropriate Push-in connector (8): white to white and black to black and
green to green or bare copper ground wire. See Fig. 4.
10. Bundle wires in tight grouping to be out of the way and reconnect
Wire Connectors (4). Reinstall LED Cover Assembly (2).
11. If using only one fi xture- skip to Step 14. If there are other fi xtures to
be installed on this chain-proceed with Step 12.
Continue to page 6
Page 4
Figure 1
Screw Hole Location
Figure 2
3/8"- 7/16"
Figure 3
Figure 4
Publicidad
Tabla de contenido
