Important Safeguards - Kalorik USK CHM 16314 Manual De Instrucciones

Fax +32 2 359 95 50

IMPORTANT SAFEGUARDS

When using your appliance, basic safety precautions should always
be followed, including the following:
1. READ ALL INSTRUCTIONS carefully before using your appliance.
2. Do not operate the motor without melted chocolate in the bowl.
The chocolate acts like a lubricant for the auger and upper part.
If the motor is switched on without the chocolate, this could
damage the unit.
3. Check that your mains voltage corresponds to that stated on the
rating plate of the appliance before using the appliance.
4. Do not unplug by pulling on the cord. To unplug, grasp the plug,
not the cord.
5. To protect against electric shock, do not immerse cord, plug or
any part of the motor base in water or other liquids. Do not place
the motor base in the dishwasher.
6. Never place anything else than the intended ingredients in the
base bowl.
7. Close supervision is necessary when used by or near children or
infirm persons.
8. Do not leave unit unattended while in use or when plugged into
an outlet.
9. Unplug from the outlet when not in use, before removing or fixing
parts and before cleaning.
10. Do not operate the appliance with a damaged cord or plug, or
after the appliance has been damaged in any manner. If the
supply cord or appliance is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard.
11. The use of attachments that are not recommended or sold by
manufacturer may cause, fire electric shock or injury.
12. Do not use outdoors.
13. Never place the appliance on or near a hot surface.
14. To reduce the risk resulting of becoming entangled or tripping
over a long cord a short power supply cord is provided.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
2
USK CHM 16314 /CHM 32074 - 091125
Assembly page 2/24