Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
4. PRIORITY LED - When this LED lits, it indicates that source 1 has the priority state activated. In that case, when the
source 1 will be activated, it will have override the rest of input sources.
5. Input Source selectors - These buttons allow to select the input source connected in the rear side. Take it in account
that each button select a pair of RCA connections: pushing SOURCE 1 , will be selected input marked as 1 and 5,
SOURCE 2, will be selected input marked as 2 and 6 and son on.
6. Switch ON/OFF - This switch allow to power on or off the device.

3.2 Rear Panel

7
1. RS 485 INTERFACE - It allows to receive/send ASCII commands control or DMX frame. Observe the correct polarity
before connecting.
2. RS 232 INPUT - It allows to receive RS 232 commands control. Observe the correct polarity before connecting.
3. UNBALANCED INPUTS - These 8 RCA unbalanced inputs allows to send several audio sources selected by the encoder
or using DMX. Also can be selected each pair of inputs (1-5, 2-6, 3-7, 4-8) using the frontal source selectors (5).
4. MIC INPUT - It allows to connect a microphone for priority function. This microphone can be dynamic or electret. The
phantom power for electret type will be set by software.
NOTE: In case of the phantom power will be activated and connected a dynamic microphone, this will not be damaged.
NOTE: The priority feature must be configured by software.
5. OUTPUT 1/OUTPUT 2 - DCA 1 provides 2 powered outputs with different volume control and input source assignation
(by software). Connect the loudspeaker system in the corresponding output.
6. MONITOR OUTPUT - This unbalanced output allow to send the final signal to an external system as amplified system or
monitoring purpose.
7. POWER INPUT - Connect the included IEC-schucko cable to power on the device.
5
6
3
4
3
User Manual/Manual de Uso
2
1
DCA 1

Publicidad

Tabla de contenido
loading

Tabla de contenido