Work Pro DCA 1 Instrucciones De Usuario página 5

4. SETUP VIA SOFTWARE
DCA 1 incorporates several features that must be configured using the frontal encoder. This encoder allow to navigate
through menus rotating it clockwise and counter-clockwise and confirming each value pushing it.
0_1:000 1
0_2:000
This is an example of the initial windows where:
0_1:
Indicates OUTPUT 1,
assignet to OUTPUT 1.
0_2:
Indicates OUTPUT 2,
assignet to OUTPUT 2.
Now, push the encoder to enter in the menus system.
1. OUTPUT VOLUME
1.-VOLUME(0-100)
CH1:083 CH2:099
It is possible to configure the volume on each output separately. Pushing the encoder, the symbol
will blink indicating the possibility to change the volume in OUTPUT 1. Turn the encoder clockwise to increase the
volume or counter-clockwise to reduce it. when reach the correct value, push the encoder, the symbol
CH2
will blink to change this value. After to confirm this second value, turn the encoder to pass to next menu.
2. PRIORITY MENU
2.-PRIORITY MENU
SETUP (push)
Push the encoder to enter in the PRIORITY sub-menus
3
000
indicates the volume on this output and
000
indicates the volume on this output and
4
1
3
User Manual/Manual de Uso
(in that case), the input source
(in that case), the input source
:
beside
:
beside
DCA 1
EN
CH1