Human Touch ht140 Manual Del Usuario página 6

take control
FRONT
Power — Lights to indicate that
master power switch is on.
Width — Focus or diffuse massage
pressure by selecting the wide, standard,
or narrow massage width setting.
Select the width setting after selecting
percussion or rolling massage modes.
Position — Use this button along with any
stationary massage technique, to set the
massage rollers to the desired position on
the backrest. You can press this button
before or after selecting the massage mode.
Stretch — Press the Stretch button for up
to 15 seconds to activate (the remote beeps
twice when ready). The chair performs a
gentle full-body stretch.
Foot and Calf Massage — Toggles
through two massage speeds and
auto, which alternates speeds.
Position Controller
To select a position setting, use your
thumb to push the controller in the
direction of the desired setting.
Legs up — Raises the foot and calf
massager to a horizontal position.
Legs down — lowers the foot and calf
massager to a vertical position.
Backrest up — Reclines the backrest
to a horizontal position.
Backrest down — Raises the backrest
to a vertical position.
humantouch.com
Session Timer — Counts down the time
remaining in the currently selected 15-minute
Auto Massage Program. The Session Timer
does not start again at 15 minutes when you
change massage modes. 15 minutes is the
recommended maximum massage duration .
Zone — Targets your massage to a six-inch
zone. Use the Position buttons to focus
your massage on the desired area.
Massage Techniques — Five massage
techniques let you customize your
massage. Each massage technique button,
except rolling, toggles through two speeds
and auto, which alternates speeds.
Stop — Stops the massage and parks
the massage rollers at the top of the
backrest.
8
Now choose a massage mode. Your Human Touch massage chair lets you customize your
massage using a wide variety of massage techniques. Choose from four stationary massage
techniques and a rolling massage, or combine them. Use the Range button to tailor your
vertical massage range, or the Zone and Position buttons to target your massage to a
specific area (see opposite page). Or, let the chair take control – just select one of the
three auto programs, which alternate massage modes and target different areas of your
back. No matter how you use it, Robotic Massage Technology
flexibility and refreshing benefits.
SIDE
Massage Programs massage the
specified area of your back for 15
minutes, using a variety of massage
techniques. The corresponding LED
lights on the remote to indicate which
massage mode is currently in use.
Upper – massages your entire back
Full – massages just your upper back
Lower – massages just your lower back
9
offers maximum massage
™
Range — Press to select tall, medium,
or short, based on your height, to position
the massage rollers for maximum comfort.