Platter Display Overview; Rear Panel - Denon DJ LC6000 PRIME Guia Del Usuario

26. Loop In/Loop Out: Press either of these buttons to create a Loop In or Loop Out point at the current location. Their
placement will be affected by the Quantize and Smart Loops settings.
27. Auto Loop/Loop Move: Turn this knob to set the size of an automatic loop. The value will be shown in the
touchscreen and platter display.
Press this knob to activate or deactivate an automatic loop at the current location of the track.
Tip: You can assign auto loops to pads in Manual Loop Mode. See
information.
Press and hold Shift and turn this knob to shift the active loop to the left or right.
28. Beat Jump: Press either of these buttons to skip backward or forward through the track. Use the Auto Loop knob
to determine the beat jump size.
Press and hold Shift and then press one of these buttons to search backward or forward through the track.

Platter Display Overview

Normally, the platter display shows the following information:
•
the current position of the playhead.
•
the album artwork of the current track.
The platter display temporarily shows the following information:
•
the current size of an auto loop after you turn the Auto Loop knob.
•
the position of the secondary playhead when Slip is active.

Rear Panel

1. Power Button: Press this button to power LC6000
PRIME on or off.
2. Power Input: Use the optional power adapter
(included) to connect this input to a power outlet.
3. USB Port: Use a standard USB cable (included) to
connect this USB port to an available USB port on a
compatible Denon DJ media player or to your
computer. This connection powers LC6000 PRIME
and sends and receives MIDI messages to and from
the media player or computer.
Note: While most media players and computers can
power LC6000 PRIME using the USB port, some may
not supply enough power and will require the power
adapter to be used.
6
Operation > Performing > Pad Modes
3
for more
2 1