Maintenance; Transportation, Storage And Disposal; Transport And Storage - RedMax CA-EX230 Manual Del Usuario

Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To replace the blades
1. Loosen the split pin.
2. Remove the cutter package from the gear housing's
output axle.
3. Mount the cutter package onto the gear housing's
output shaft. Make sure the direction of rotation
agrees with the cutters and on the gear. The arrows
must point in the same direction.

Transport and storage

If transporting the attachment on another vehicle always
use approved securing devices and make sure that the
attachment is securely held.
8

Maintenance

Transportation, storage and disposal

To perform daily maintenance on the
product
1. Check that the guard is undamaged and not
cracked. Replace the guard if it has been exposed to
impact or is cracked.
2. Check that the blades do not move when the engine
is idling.
3. Check that the blades are undamaged and show no
signs of cracking or other damage. Replace the
blades if necessary.
4. Check that nuts and screws are tight.
5. Clean the outside of the product.
6. Check that the split pins and cotter pins are
undamagad and secured correctly.
Ensure the attachment is cleaned and that a complete
service is carried out before long-term storage.
410 - 003 - 23.01.2020