On/Off Switch - BaByliss PRO GOLDFX FX787G Instrucciones De Operación

4. Connect the charging jack into the receptacle on the bottom of the trimmer. Plug
the adapter into any electrical outlet (at the voltage listed on the label affixed to
the adapter). The charging indicator will light up to indicate that the charging has
begun. Charging is complete after 3 hours. User will see LED light has stopped
blinking and is now steady lit.
5. The adapter may become warm while charging. This is normal.
6. Preserving the batteries: In order to maintain the optimum capacity of the
rechargeable batteries, the trimmer should be recharged for 3 hours approximately
every 6 months.
7. Slide the switch to "I" position.
8. Make sure the switch is in the "0" position when the trimmer is not operating.
9. Remove hair trimmings and debris from the blades using the provided cleaning
brush. Wipe the housing clean with a dry cloth.
10. Apply a few drops of lubricating oil to the blades, and wipe off any excess oil with a
dry cloth. This last procedure is important for the proper maintenance of the blades.
11. If the charging light starts to flash rapidly (more than 4 flashes per second) then
the appliance is faulty. If this happens then please stop charging and remove the
adapter from the mains and contact an authorized Service Center.
WARNING:
Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to operate the
equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
FX787G IB-16251A.indd 5-6
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by Conair Corporation,
the manufacturer of this product and the party responsible for compliance, could void
the user's authority to operate the equipment.
FOR DIRECT PLUG-IN OPERATION
Make sure trimmer is off. Connect charging jack into the receptacle at the end of
trimmer and plug the adapter into power outlet.

ON/OFF SWITCH

To operate, simply slide switch to "I" position. To stop operation, set to the "0" position.
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for
proper functioning. Failure to regularly clean and oil the blades will void the
warranty.
2019/5/21 5:09 PM